Changan CS35 - Engine Control Module; Remove the Engine Control Module; Removal and Installation

3.1.13-250
CS35 2013.04
3.1.13-250Electronic Control System - ME7
Removal and Installation
Engine Control Module
Removal
Installation
1. To install, reverse the removal procedure.
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Remove the engine control module.
1. Disconnect the engine control module wir-
ing harness connector.
2. Remove the 4 retaining bolts of the engine
control module.
3. Take out the engine control module.
Torque: 10 Nm
2
×4
1
A3113135
mashinesoft.com
09120146259