3.1.13-80
CS35 2013.04
3.1.13-80Electronic Control System - ME7
Failure Protection List
DTC Code Description
Failure Protection
Operation
Prerequisite of
Releasing Failure
Protection
P000A, P0012 Intake VVT fault Repair fault
P0010, P2088,
P2089
Intake VVT hydraulic control valve
circuit fault
Disable variable intake con-
trol
Remove circuit faults
between intake oil con-
trol valve and ECM, or
replace the intake oil
control valve
P000B, P0015 Exhaust VVT fault Repair fault
P0013, P2090,
P2091
Exhaust VVT hydraulic control
valve circuit fault
Disable variable exhaust
control
Remove circuit faults
between exhaust oil
control valve and
ECM, or replace the
exhaust oil control
valve
P0016, P0017
Relative installation position of
camshaft and crankshaft unrea-
sonable
Camshaft control off
Camshaft and crankshaft
relative position self - learn-
ing off
Misfire detect off
Inspect the camshaft
and crankshaft mount-
ing location
P0030, P0031,
P0032, P0053
Pre - catalytic oxygen sensor
heating control circuit fault
Stop closed loop fuel control
Remove circuit faults
between the heater
and ECM, or replace
pre - catalytic oxygen
sensor
P0036, P0037,
P0038, P0054
Post - catalytic oxygen sensor
heating control circuit fault
Disable post - catalytic
oxygen sensor
Remove circuit faults
between Post -
catalytic oxygen
sensor and ECM, or
replace the Post -
catalytic oxygen
sensor
P0105, P0106,
P0107, P0108
Inlet air pressure sensor signal
fault
1. Rear oxygen close loop
control
2. Catalyst heating function
3. %DKAT catalyst testing
close
4. %DKVS fuel supply self -
learning diagnosis
5. Minimum idle fault
6. %DLSA function off
Remove circuit faults
between MAP sensor
and ECM, or replace
the intake pressure &
temperature sensor
mashinesoft.com
09120146259
To Next Page
Loading...
Need help?
General
