Changan CS35 - Air Intake Pressure;Temperature Sensor

CS35 2013.04
3.1.13-255 3.1.13-255Electronic Control System - ME7
Air Intake Pressure/Temperature Sensor
Removal
Installation
1. To install, reverse the removal procedure.
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Remove the intake air pressure temperature
sensor.
1. Disconnect the air intake pressure temper-
ature sensor wiring harness connector.
2. Remove the retaining bolt on the air intake
pressure temperature sensor.
3. Take out the intake air pressure tempera-
ture sensor.
Torque: 10 Nm
1
2
A3113146
mashinesoft.com
09120146259