Changan CS35 User Manual

3.1.13-92
CS35 2013.04
3.1.13-92Electronic Control System - ME7
A/C clutch
Enable A/C compressor clutch
relay
On / Off
Test conditions for closed air
conditioning clutch: No actu-
ator control restriction. Test
conditions for open air con-
ditioning: the engine shall
stop running.
The function controls A/C compressor
relay. When the instruction is "ON", the
A/C compressor relay will be ON / OFF
within 3 ~ 5 s.
Throttle position
controller
Enable the electronic throttle
actuator motor
0 ~ 100
CAUTION: This function
could be carried out only
when the engine stops run-
ning and the vehicle speed is
zero.
Control the throttle actuator motor con-
trol command, which is between 0 ~
100, realizing control of throttle open-
ing.
Idle speed control
Control engine speed to set
speed
0 ~ 2,550
CAUTION: This function
could be carried out only
when the engine idle speed
is lower than 1,000 RPM and
the vehicle speed is zero.
Control the idle speed control com-
mand, which is between 0 ~ 2,550,
realizing control of engine idle speed.
Reset ECU self -
learning value
Clear self - learning value that
been stroed by engine
Reset /
Return
CAUTION: Carry out the test
only when ignition switch is
at "ON" position, engine is
not running.
Clear self - learning value that been
stroed by engine.
Diagnostic Tool
Display Item
Description
Control
Range
Diagnostic Description
mashinesoft.com
09120146259

Changan CS35 Specifications

General

Brand	Changan
Model	CS35
Category	Automobile
Language	English