Changan CS35 - Pre-Catalytic Oxygen Sensor; Special Tool

CS35 2013.04
3.1.13-257 3.1.13-257Electronic Control System - ME7
Pre-Catalytic Oxygen Sensor
Special Tool
Removal
Installation
1. To install, reverse the removal procedure.
Oxygen Sensor Sleeve
CA301-022
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Disconnect the pre-catalytic oxygen sensor
wiring harness connector.
3. Remove the pre-catalytic oxygen sensor with
the oxygen sensor sleeve.
Torque: 50 Nm
Special Tool: CA301-022
CA301-022
A3113151
A3113153
mashinesoft.com
09120146259