CS35 2013.04
3.1.13-237 3.1.13-237Electronic Control System - ME7
DTC P2106
1. DTC Description
2. Possible Sources
3. Diagnosis Procedures
Fault Code Description Definition
P2106
Electronic throttle dirve level
fault
Fault
Code
Test Tactics
Setting Conditions (Control
Strategy)
Fault
P2106
Throttle actuator
control system
force power limita-
tion
• The engine is at the idle state.
• The accelerator pedal position sensor
signal 1 and signal 2 is disconnected
at the same time and relative sensor
fault exists.
• Relative sensor DTC appears and the
engine enters into the limit execution
state.
• Solenoid
• Solenoid circuit
•ECM
Test Conditions Details/Results/Actions
1. Inspect if there is DTC other than DTC P2106 in control system
A. Connect the diagnostic tool to fault diagnosis
interface.
B. Turn the ignition switch to position "ON".
C. Press the power button of the diagnostic tool.
D. Select "Changan Auto" / "CS35" / "UMC ME788" /
"Read DTC".
E. Read the DTC.
Is there any DTC other than DTC P2106 ?
Y
Carry out the DTC diagnosis.
Refer to: DTC Diagnostic Procedure Index
(3.1.13 Electrical Control System - ME7,
DTC Diagnosis and Testing).
N
Go to step 2.
mashinesoft.com
09120146259
To Next Page
Loading...
