3.1.13-86
CS35 2013.04
3.1.13-86Electronic Control System - ME7
Data Stream List
By reading the "Data Stream List" on the fault diagnostic tool, do not remove any component, and
inspect the working state of the switches, the sensors, and the actuators. Before the fault diagnosis of
the engine electrical control system, the observation and analysis of the data is the first step in trouble-
shooting, this can reduce the troubleshooting time.
CAUTION: The following table lists the data under normal conditions, only for reference. Do
not determine the failure based on these standard values. Generally, use a normal vehicle to
compare a vehicle in diagnosis under the same state to determine the data of the diagnosis
vehicle uner the current state normal or not.
1. Let the engine reach normal operating temperature.
2. Turn the ignition switch to position "LOCK".
3. Connect the fault diagnostic tool.
4. Turn the ignition switch to position "ON".
5. Select "Changan Auto" / "CS35" / "UMC ME788 (AT)" / "read the data stream".
6. Refer to the chart below to inspect all the data.
mashinesoft.com
09120146259
To Next Page
Loading...
Need help?
General
