Changan CS35 - Accelerator Pedal Position Sensor

3.1.13-260
CS35 2013.04
3.1.13-260Electronic Control System - ME7
Accelerator Pedal Position Sensor
Removal
Installation
1. To install, reverse the removal procedure.
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Disconnect the accelerator pedal position
sensor assembly wiring harness connector.
3. Remove the accelerator pedal position
sensor assembly retaining bolt, and take out
the accelerator pedal position sensor
assembly.
Torque: 23 Nm
A3113159
×3
A3113149
mashinesoft.com
09120146259