Changan CS35 - Crankshaft Position Sensor

CS35 2013.04
3.1.13-251 3.1.13-251Electronic Control System - ME7
Crankshaft Position Sensor
Removal
Installation
1. To install, reverse the removal procedure.
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Remove the crankshaft position sensor.
1. Disconnect the crankshaft position sensor
wiring harness connector.
2. Remove the crankshaft position sensor
retaining bolt.
3. Detach the crankshaft position sensor.
Torque: 10 Nm
1
2
A3113136
mashinesoft.com
09120146259