3.1.13-96
CS35 2013.04
3.1.13-96Electronic Control System - ME7
P0221
Unreasonable electronic throttle position sen-
sor signal 2
Refer to: DTC P0221, P0222 and
P0223
P0222
Electrical throttle position sensor signal 2 cir-
cuit voltage too low
P0223
Electrical throttle position sensor signal 2 cir-
cuit voltage too high
P0300 Multi - cylinder misfire
Refer to: DTC P0300, P0301, P0302,
P0303, P0304
P0301 Cylinder 1 misfire
P0302 Cylinder 2 misfire
P0303 Cylinder 3 misfire
P0304 Cylinder 4 misfire
P0317 Circuit test ABS signal fault
Refer to: DTC P0317, P0501, P1523
P0501 Speed sensor signal fault
P1523 Airbag activated
P0321
Crankshaft upper dead point missing teeth
signal unreasonable
Refer to: DTC P0324, P0325
P0322 Speed sensor signal fault
P0327 Knock sensor signal circuit voltage is too low
Refer to: DTC P0335, P0336
P0328 Knock sensor signal circuit voltage is too high
P0340 Phase sensor is installed in improper position
Refer to: DTC P0340, P0341, P0342,
P0343
P0341 Intake phase sensor with poor contact (Bank1)
P0342
Short circuit to ground of the intake phase
sensor (Bank1)
P0343
Short (or open) circuit to power supply of the
intake phase sensor (Bank1)
P0365
Exhaust phase sensor is installed in improper
position (Bank1)
Refer to: DTC P0340, P0341, P0342,
P0343
P0366
Exhaust phase sensor with poor contact
(Bank1)
P0367
Short circuit to ground of the exhaust phase
sensor (Bank1)
P0368
Short (or open) circuit to power supply of the
exhaust phase sensor (Bank1)
P0420
Three - way catalytic converter oxygen stor-
age capacity aging (exceed the emission lim-
its)
Refer to: DTC P0420
Fault Code Description Diagnosis Procedures
mashinesoft.com
09120146259