3.1.13-174
CS35 2013.04
3.1.13-174Electronic Control System - ME7
6. Inspect the ignition system
A. Turn the ignition switch to position "LOCK".
B. Carry out the ignition spark test.
Refer to: Ignition Spark Test (3.1.8 Ignition
System, General Procedures).
Is the spark plug ignition spark test normal?
Y
Go to step 7.
N
Inspect the ignition system.
Refer to: Diagnosis procedures for spark
plugs not flash over (3.1.8 Ignition Sys-
tem, Symptom Diagnosis and Testing).
7. Inspect the fuel pressure
A. Turn the ignition switch to position "LOCK".
B. Measure the fuel pressure.
Refer to: Fuel System Pressure Test (3.1.7
Fuel System, General Procedures).
Is the fuel pressure normal?
Y
Go to step 8.
N
Inspect the fuel system.
Refer to: Fuel Pump Malfunction Diagno-
sis (3.1.7 Fuel System, Symptom
Diagnosis and Testing).
8. Inspect the compression pressure
A. Inspect the engine compression pressure.
Refer to: Cylinder Compression Pressure
Inspection (3.1.2 Mechanical System, Gen-
eral Procedures).
Is the compression pressure normal?
Y
Go to step 9.
N
Eliminate the low compression pressure fault.
Test Conditions Details/Results/Actions
mashinesoft.com
09120146259
To Next Page
Loading...
