Changan CS35 - Page 246

3.1.13-230
CS35 2013.04
3.1.13-230Electronic Control System - ME7
2. Inspect the DTC
A. Connect the diagnostic tool to fault diagnosis
interface.
B. Turn the ignition switch to position "ON".
C. Press the power button of the diagnostic tool.
D. Select "Changan Auto" / "CS35" / "UMC ME788" /
"Read DTC".
E. Read the DTC.
Are there any DTC expect P1336, P1545, P1558,
P1568?
Y
Carry out the DTC diagnosis.
Refer to: DTC Diagnostic Procedure Index
(3.1.13 Electrical Control System - ME7,
DTC Diagnosis and Testing).
N
Go to step 3.
3. Inspect the electronic throttle
A. Inspect the electronic throttle for carbon depositon
or clamping.
B. Remove the connector between the electronic
throttle and air intake pipe.
C. Turn the ignition switch to position "ON".
D. One person step down the accelerator pedal,
another person observe if the opening of electronic
throttle changes with the change of accelerator
pedal opening.
Is the electronic throttle normal?
Y
Go to step 4.
N
Repair it or install a new one.
Test Conditions Details/Results/Actions
mashinesoft.com
09120146259