Changan CS35 - Page 269

CS35 2013.04
3.1.13-253 3.1.13-253Electronic Control System - ME7
Camshaft Position Sensor
Removal
Installation
1. To install, reverse the removal procedure.
1. Disconnect the battery negative cable.
Refer to: Battery Inspection (3.1.10 Charg-
ing System, General Procedures).
2. Disconnect the camshaft position sensor
wiring harness connector.
3. Remove the camshaft position sensor.
1. Remove the camshaft position sensor
retaining bolt.
2. Take out the camshaft position sensor.
Torque: 10 Nm
A3113142
A3113143
mashinesoft.com
09120146259