CS35 2013.04
3.1.13-27 3.1.13-27Electronic Control System - ME7
4. Inspect the engine compression pressure
A. Inspect the engine compression pressure.
Refer to: Cylinder Compression Pressure
Inspection (3.1.2 Mechanical System, Gen-
eral Procedures).
Is the cylinder compression pressure normal?
Y
Go to step 5.
N
Inspect the engine mechanical system.
5. Inspect the engine immobilizer system
A. Inspect the engine immobilizer system.
Is the engine immobilizer system activated?
Y
Repair the immobilizer system, remove the immobi-
lizer activation.
Refer to: ECM Always Detects That the
Engine Anti - theft Unreleased Fault Diag-
nosis (3.1.12 Immobilizer System,
Symptom Diagnosis and Testing).
N
Go to step 6.
6. Inspect the water in the fuel
A. Remove the fuel filter joint.
Refer to: Replace Fuel Filter (3.1.7 Fuel
System, Removal and Installation).
B. Drain the fuel in the fuel filter and inspect the water
in the fuel.
Is there any water in fuel tank?
Y
Remove the water that mixed in the fuel, add high
standard pure fuel.
N
Go to step 7.
Test Conditions Details/Results/Actions
mashinesoft.com
09120146259
To Next Page
Loading...
Need help?
General
