Changan CS35 User Manual

CS35 2013.04
3.1.13-33 3.1.13-33Electronic Control System - ME7
4. Inspect the water temperature sensor
A. Disconnect the connector E22 of the water
temperature sensor.
B. Install in series of a 300 Ω resistor at the
temperature sensor joints to replace the water
temperature sensor.
C. Start the engine.
Can the engine be started easily?
Y
Replace the water temperature sensor.
N
Go to step 5.
5. Inspect the fuel
Is the fault caused by just refueling?
Y
Replace the fuel.
N
Go to step 6.
6. Inspect the ECM power supply circuit
A. Turn the ignition switch to position "LOCK".
B. Measure from the back of ECM wiring harness
connector E01.
C. Turn the ignition switch to "ON" position and use a
multimeter to measure the voltage between the
terminals 12, 13, 44,45 and 63 of the ECM wiring
harness connector E01 and the power supply.
Standard Voltage Value: 11 ~ 14 V
Is the voltage normal?
Y
Go to step 7.
N
Repair and inspect the ECM power supply circuit.
Test Conditions Details/Results/Actions
12
3
45
624
2543
4462
63
13
12
45
81
E01
A3113031
mashinesoft.com
09120146259

Changan CS35 Specifications

General

Brand	Changan
Model	CS35
Category	Automobile
Language	English