3.1.13-50
CS35 2013.04
3.1.13-50Electronic Control System - ME7
7. Inspect the air intake pressure sensor and the throttle position sensor
A. Turn the ignition switch to position "LOCK".
B. Connect the diagnostic tool.
C. Start the engine and inspect the data stream of the
air intake pressure sensor and the throttle position
sensor.
Is the data stream of the air intake pressure sensor
and throttle sensor normal?
Y
Go to step 8.
N
Replace air intake pressure sensor and throttle sen-
sor or repair sensor circuit.
8. Inspect the ignition timing
A. Inspect the ignition sequence.
B. Inspect the ignition timing.
Refer to: Timing Inspection (3.1.2 Mechan-
ical System, General Procedures).
Are the ignition sequence and ignition timing nor-
mal?
Y
Go to step 9.
N
Adjust the ignition timing.
9. Inspect the engine support component
A. Inspect the engine support component.
Are the engine suspension component cracked,
damaged, bolts loose or lost?
Y
Repair the fault part.
N
Go to step 10.
Test Conditions Details/Results/Actions
mashinesoft.com
09120146259