158
CP30 Mobile Computer
Reference Manual
2 Data packet containing the data following an escape
mechanism character. The data packet does not support the
ECI protocol.
3 Data packet containing the data following an escape
mechanism character. The data packet supports the ECI
protocol.
GS1-128 emulation
1 Data packet is a GS1-128 barcode (= data is preceded with
“]JC1”).
Note: UPC portion of composite is transmitted using UPC rules.
0 Scan engine is set to conform to protocol defined in 1994
PDF417 symbology specifications.
When this option is transmitted, the receiver cannot
reliably determine whether ECIs have been invoked or
whether data byte 92
DEC
has been doubled in
transmission.
1 Scan engine is set to follow the ECI protocol (Extended
Channel Interpretation). All data characters 92
DEC
are
doubled.
2 Scan engine is set for Basic Channel operation (no escape
character transmission protocol). Data characters 92
DEC
are
not doubled.
When decoders are set to this mode, unbuffered Macro
symbols and symbols requiring the decoder to convey
ECI escape sequences cannot be transmitted.
3 The barcode contains a GS1-128 symbol, and the first
codeword is 903-907, 912, 914, 915.
4 The barcode contains a GS1-128 symbol, and the first
codeword is in the range 908-909.
5 The barcode contains a GS1-128 symbol, and the first
codeword is in the range 910-911.
PDF417,
Micro PDF417
A PDF417 barcode, ABCD, with no transmission protocol enabled, is
transmitted as ]L2ABCD.
0 ECC 000-140, not supported.
1 ECC 200.
2
ECC 200, FNC1 in first or fifth position.
3
ECC 200, FNC1 in second or sixth position.
4 ECC 200, ECI protocol implemented.
5
ECC 200, FNC1 in first or fifth position, ECI protocol
implemented.
Data Matrix
6
ECC 200, FNC1 in second or sixth position, ECI protocol
implemented.
0 Mode 4 or 5 Maxicode
1 Mode 2 or 3
To Next Page
Loading...
