Circutor CVM-C11 - 6�5�- Primary Neutral Current

Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 25:Configuration values: Secondary current.
Secondary current
Possible values
1 A
5 A
Press key to access the next programming step.
6.5.- PRIMARY NEUTRAL CURRENT
Note: Parameter not available in model CVM-C11-FLEX-IN-485-ICT2.
The neutral current transformer primary is programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
To validate the data, press for 3 seconds and the icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
Configuration values
Table 26:Configuration values: Primary neutral current.
Primary neutral current
Minimum value 1
Maximum value 10000
Press key to access the next programming step.
60
CVM-C11
Instruction Manual