When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
Press key to browse the different tariffs.
To validate the data, press for 3 seconds and the icon will disappear from the display.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
Configuration values
Table 47:Configuration values: cost ratio, generated energy.
Cost ratio, generated energy
Minimum value 0
Maximum value 1.9999
Press key to access the next programming step.
6.25.- PROGRAMMING THE ALARM RELAY 1
In this step, all the values corresponding to alarm relay 1 are programmed.
The variable code is selected on this screen, depending on Table 48 and Table 49, which will control
alarm relay 1.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
When you enter the code of a variable on the display, the symbols for that variable will be activated.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Note: Set the value to 000 if you do not wish to program a variable.
75
Instruction Manual
CVM-C11
To Next Page
Loading...
