Circutor CVM-C11 - 6�25�4�- Hysteresis Value

Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 51:Configuration values: Connection time delay.
Connection time delay
Minimum value 0 seconds
Maximum value 9999 seconds
Press key to access the next programming step.
6.25.4.- HYSTERESIS VALUE
The hysteresis value, i.e., difference between the alarm connection and disconnection value, in %, is
programmed on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 52:Configuration values: Hysteresis value.
Hysteresis value
Minimum value 0 %
Maximum value 99 %
Press key to access the next programming step.
79
Instruction Manual
CVM-C11