Circutor CVM-C11 - 6�27�2�- Pulse Width; 6�28�- Programming Alarm 4 (Digital Output T2)

6.27.2.- PULSE WIDTH
The width of the pulse is selected on this screen in ms.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 58:Configuration values: Pulse width.
Pulse width
Minimum value 30 ms
Maximum value 400 ms
Press key to access the next programming step.
6.28.- PROGRAMMING ALARM 4 DIGITAL OUTPUT T2
All values for digital output T2 are programmed on this screen.
The programming is the same as for digital output T1, see “6.27.- PROGRAMMING ALARM 3 DIGITAL
OUTPUT T1”.
84
CVM-C11
Instruction Manual