6.25.5.- LATCH
The latch is selected on this screen, i.e., if the alarm is interlocked after it has been tripped, even when
the condition that triggered it has disappeared.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 53:Configuration values: Latch.
Latch
Possible values
Yes
No
Note: If the device is reset, the status of alarms is deleted and all alarms will return to the programmed
standby status, provided that the condition that triggered them has been resolved.
Press key to access the next programming step.
6.25.6.- DISCONNECTION DELAY
The alarm disconnection delay is programmed on this screen in seconds.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
To validate the data, press for 3 seconds and the icon will disappear from the display.
80
CVM-C11
Instruction Manual
To Next Page
Loading...
