Circutor CVM-C11 - 7�2�- Modbus Tcp Protocol: Dhcp; 7�3�- Modbus Tcp Protocol: Ip Adress

7.2.- MODBUS TCP PROTOCOL: DHCP
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
On this screen you select whether or not to enable DHCP. If DHCP enable is selected (default setting),
the IP address is assigned dynamically through a central server and no further parameters need to
be configured.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
The key jumps between the possible options.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 72:Configuration values: Modbus TCP, DHCP.
Modbus TCP: DHCP
Possible values
Yes, DHCP enabled
no, DHCP not enabled
Press key to access the next programming step.
7.3.- MODBUS TCP PROTOCOL: IP ADRESS
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
This screen configures (DHCP not enabled) or displays the IP address.
Press the key to display the value.
95
Instruction Manual
CVM-C11