Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values. The key jumps to the previous digit.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Press key to access the next programming step.
7.4.- MODBUS TCP PROTOCOL: MASK
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
On this screen the IP mask is configured (DHCP not enabled) or displayed.
Press the key to display the value.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values. The key jumps to the previous digit.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Press key to access the next programming step.
96
CVM-C11
Instruction Manual
To Next Page
Loading...
