7.5.- MODBUS TCP PROTOCOL: GATEWAY
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
This screen configures (DHCP not enabled) or displays the gateway for Ethernet communications.
Press the key to display the value.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values. The key jumps to the previous digit.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Press key to access the next programming step.
7.6.- MODBUS TCP PROTOCOL: MAC ADRESS
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
This screen displays the MAC address of the device.
Press the key to display the value.
Note: This parameter cannot be modified.
Press key to access the next programming step.
97
Instruction Manual
CVM-C11
To Next Page
Loading...
