Circutor CVM-C11 - 7�7�- Modbus Tcp Protocol: Port; 7�8�- Bacnet Protocol: Port

7.7.- MODBUS TCP PROTOCOL: PORT
Note: Screen visible if the Modbus TCP protocol has been programmed, “7.1.- PROTOCOL”.
The Ethernet communications port is configured on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values. The key jumps to the previous digit.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Press key to access the next programming step.
7.8.- BACNET PROTOCOL: PORT
Note: Screen visible if the BAcnet protocol has been programmed, “7.1.- PROTOCOL”.
The Ethernet communications port is configured on this screen.
Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values. The key jumps to the previous digit.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Press key to access the next programming step.
98
CVM-C11
Instruction Manual