Press key for 3 seconds to edit the value. The icon appears at the top of the screen.
To enter or modify the value, press the key repeatedly, increasing the value of the flashing digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key to
modify the other values.
The programmed value will be deleted if the entered value is higher than the maximum programming
value.
To validate the data, press for 3 seconds and the icon will disappear from the display.
Configuration values
Table 70:Configuration values: Password.
Password
Default value 1234
This value may only be modified through communications. See “8.3.9.18. Password configuration.”
Press the key to exit the setup menu.
Note: The device will restart after exiting the setup menu if the RS-485 communications parameters
have been modified.
93
Instruction Manual
CVM-C11
To Next Page
Loading...
