Circutor CVM-E3-MINI - 6�7�- Measurement Convention; 6�8�- Measurement System

 Configuration values
Table 26: Configuration values: Number of quadrants.
Number of quadrants
Possible values 2 4
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
6.7.- MEASUREMENT CONVENTION
You can select the measurement convention of the device from this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
The key is used to browse the different options.
 Configuration values
Table 27: Configuration values: Measurement convention.
Measurement convention
Possible values
Cir
Circutor measurement convention.
IEC
IEC measurement convention
IEEE
IEEE measurement convention
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
6.8.- MEASUREMENT SYSTEM
The measurement system is selected on this screen.
60
CVM-E3-MINI
Instruction Manual