6.20.- TARIFF SELECTION (Models CVM-E3-MINI-xxx-WiEth)
You can select the operating tariff on this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press key to browse the two options.
Configuration values
Table 50: Configuration values: Tariff.
Tariff
Possible values
t1
Tariff 1
t2
Tariff 2
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
6.21.- BACKLIGHT, TURNING ON THE BACKLIT DISPLAY
This screen is used to programme the maximum brightness time of the display since the device was
last used with the keypad. After this time, the display will reduce the brightness level.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press the key to modify the value of the flashing digit.
When the desired value is shown on the screen, use the and keys to move the edit cursor.
77
Instruction Manual
CVM-E3-MINI
To Next Page
Loading...
