Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press the key to modify the value of the flashing digit.
When the desired value is shown on the screen, use the and keys to move the edit cursor.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
If the value entered by the user is out of the range of programming values, the programmed value will
be deleted and the system will restore it to the last saved value.
Configuration values
Table 35: Configuration values: Carbon emissions ratio (Generated energy).
Carbon emissions ratio (Generated energy)
Minimum value 0
Maximum value
1.9999
Press key to access the next programming step.
6.16.- COST RATIO OF CONSUMED ENERGY
This screen is used to programme the cost per kWh of electricity for consumed energy, using the 2
tariffs configured for the device: T1 on the top line and T2 on the bottom line.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press the key to modify the value of the flashing digit.
When the desired value is shown on the screen, use the and keys to move the edit cursor.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
If the value entered by the user is out of the range of programming values, the programmed value will
be deleted and the system will restore it to the last saved value.
66
CVM-E3-MINI
Instruction Manual
To Next Page
Loading...
