Circutor CVM-E3-MINI - KILOWATTS PER PULSE

To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
 Configuration values
Table 45: Configuration values: Disconnection time delay.
Disconnection time delay
Minimum value 0 s.
Maximum value 999 s.
Press key to access the next programming step.
6.18.8. CONTACT STATUS
The status of relay contacts is selected on this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press key to browse options.
 Configuration values
Table 46: Configuration values: Contact status
Contact status
Possible values
nO
Normally open contact.
nC
Normally closed contact.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
6.18.9. KILOWATTS PER PULSE
Note: This screen is displayed if the alarm parameter has been selected from an energy value, see
Table 40.
This screen is used to programme the kilowatts per pulse.
74
CVM-E3-MINI
Instruction Manual