Circutor CVM-E3-MINI - 6�22�1�- Modbus Protocol: Baud Rate; 6�22�2�- Modbus Protocol: Peripheral Number

If the BACnet protocol has been selected, the next setup screen will be shown in section “6.22.6.-
BACnet PROTOCOL: BAUD RATE”.
6.22.1.- MODBUS PROTOCOL: BAUD RATE
The baud rate of modbus communications is programmed on this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press key to browse the options.
 Configuration values
Table 53: Configuration values: Modbus protocol: baud rate
Baud rate
Possible values 9600 19200 38400
(5)
57600
(5)
115200
(5)
(5)
Available on devices with software version v2.xx.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
6.22.2.- MODBUS PROTOCOL: PERIPHERAL NUMBER
The peripheral number is programmed on this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press the key to modify the value of the flashing digit.
When the desired value is shown on the screen, use the and keys to move the edit cursor.
79
Instruction Manual
CVM-E3-MINI