Circutor CVM-E3-MINI - 6�19�- OPERATING MODE of DIGITAL INPUT (Models CVM-E3-MINI-XXX)

 Configuration values
Table 48: Configuration values: Pulse width.
Pulse width
Minimum value 30 ms.
Maximum value 500 ms.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
If the value entered by the user is out of the range of programming values, the programmed value will
be deleted and the system will restore it to the last saved value.
Press key to access the next programming step.
6.19.- OPERATING MODE OF DIGITAL INPUT (Models CVM-E3-MINI-xxx)
The function of digital input 1 is selected on this screen.
Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the
screen.
Press key to browse the two options.
 Configuration values
Table 49: Configuration values: digital input.
Digital input
Possible values
lOGIC
Logic input
tARIF Tariff selection.
Note: The Digital Input can be set up as a pulse counter via RS-485 communications, see “ 7.3.9.12
Digital input (Models CVM-E3-MINI-xxx)”.
To validate the value, press the key for 3 seconds; the prog icon will stop flashing.
Press key to access the next programming step.
76
CVM-E3-MINI
Instruction Manual