Circutor CVM-E3-MINI - MAXIMUM VALUE; MINIMUM VALUE

To Next Page

To Previous Page

6.18.1. MAXIMUM VALUE

This screen is used to programme the maximum value, i.e., the value above which the alarm will be

activated.

Press the key for 3 seconds to enter the edit mode. The prog icon will flash on the left of the

screen.

Press the key to modify the value of the flashing digit.

Note: The device allows the user to configure negative values. To do so, increase the first digit to a value

higher than 9.

When the desired value is shown on the screen, use the and keys to move the edit cursor.

Note: Pay special attention when programming the Generation Power (displayed with negative values).

Example: If you wish to enter a generation power alarm with limits between 2 kW and 1 kW, program

the following as the maximum value : - 1 kW and the following as the minimum value : - 2 kW.

To validate the value, press the key for 3 seconds; the prog icon will stop flashing.

Press key to access the next programming step.

6.18.2. MINIMUM VALUE

This screen is used to programme the minimum value, i.e., the value under which the alarm will be