Procedure
Step 1
In Cisco Unified Communications Manager Administration, select Device > Phone.
Step 2
Locate the phone to be set up.
Step 3
Configure the Call Forward Notification fields.
Table 16: Call Forward Notification fields
DescriptionField
When this check box is checked, the caller name displays in the notification
window.
By default, this check box is checked.
Caller Name
When this check box is checked, the caller number displays in the notification
window.
By default, this check box is not checked.
Caller Number
When this check box is checked, the information about the caller who last
forwarded the call displays in the notification window.
Example: If Caller A calls B, but B has forwarded all calls to C and C has
forwarded all calls to D, the notification box that D sees contains the phone
information for caller C.
By default, this check box is not checked.
Redirected Number
When this check box is checked, the information about the original recipient
of the call displays in the notification window.
Example: If Caller A calls B, but B has forwarded all calls to C and C has
forwarded all calls to D, then the notification box that D sees contains the
phone information for caller B.
By default, this check box is checked.
Dialed Number
Step 4
Select Save.
Enable BLF for Call Lists
Procedure
Step 1
In the Cisco Unified Communications Manager Administration, select System > Enterprise Parameters.
Step 2
From the BLF for Call Lists drop-down list box, choose the applicable profile.
By default, the feature is disabled.
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
151
Phone Feature Configuration
To Next Page
Loading...
Need help?
General
