EasyManuals Logo

Cisco 7800 Series Administrator's Guide

Cisco 7800 Series
234 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #230 background imageLoading...
Page #230 background image
Perform Factory Reset Phone Keypad
Use these steps to reset the phone to factory default settings using the phone keypad.
Procedure
Step 1
Unplug the phone:
If using PoE, unplug the LAN cable.
If using the power cube, unplug the power cube.
Step 2
Wait 5 seconds.
Step 3
Press and hold # and plug the phone back in.
Step 4
When the phone boots up, the headset button, the speaker button, and the mute button light up. When the light
on the Mute button turns off, press 123456789*0# in sequence.
When you press 1, the lights on the headset button turns off. The light on the Select button flashes when a
button is pressed.
After you press these buttons, the phone goes through the factory reset process.
If you press the buttons out of sequence, the phone powers on normally.
Do not power down the phone until it completes the factory reset process, and the main screen
appears.
Caution
Perform Factory Reset from Phone Menu
Procedure
Step 1
Press Applications .
Step 2
To restore phone configuration or settings to factory default, press Ok.
Voice Quality Monitoring
To measure the voice quality of calls that are sent and received within the network, Cisco IP Phones use these
statistical metrics that are based on concealment events. The DSP plays concealment frames to mask frame
loss in the voice packet stream.
Concealment Ratio metrics: Show the ratio of concealment frames over total speech frames. An interval
conceal ratio is calculated every 3 seconds.
Concealed Second metrics: Show the number of seconds in which the DSP plays concealment frames
due to lost frames. A severely concealed second is a second in which the DSP plays more than five
percent concealment frames.
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
216
Voice Quality Monitoring

Table of Contents

Other manuals for Cisco 7800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7800 Series and is the answer not in the manual?

Cisco 7800 Series Specifications

General IconGeneral
WirelessNo
Video SupportNo
PoEYes, 802.3af/at
Audio Codec SupportG.711, G.722, G.729, iLBC
Network ProtocolsSIP, SDP, IPv4, IPv6, UDP, TCP, DNS, TFTP, HTTP, HTTPS, DHCP
Security Features802.1X, TLS, SRTP
Power OptionsPoE
Headset Port3.5mm
ButtonsLine keys, navigation cluster, softkeys, mute, speakerphone, headset, volume control
BluetoothNo
Ethernet SwitchYes, 2-port 10/100/1000
USB PortYes, for headset (7875)

Related product manuals