Cisco 7800 Series

Table 17: UCR 2008 Parameter Location
Administration pathParameter
Device > Device Settings > Common Phone ProfileFIPS Mode
System > Enterprise Phone Configuration
Device > Phones
Device > PhoneSSH Access
Device > Device Settings > Common Phone Profile
Device > PhoneWeb Access
System > Enterprise Phone Configuration
Device > Device Settings > Common Phone Profile
Device > Device Settings > Common Phone Profile80-bit SRTCP
System > Enterprise Phone Configuration
Device > Device Settings > Common Device ConfigurationIP Addressing Mode
Device > Device Settings > Common Device ConfigurationIP Addressing Mode
Preference for Signaling
Set Up UCR 2008 in Common Device Configuration
Use this procedure to set the following UCR 2008 parameters:
•
IP Addressing Mode
•
IP Addressing Mode Preference for Signaling
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Device Configuration.
Step 2
Set the IP Addressing Mode parameter.
Step 3
Set the IP Addressing Mode Preference for Signaling parameter.
Step 4
Select Save.
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
153
Phone Feature Configuration