Cisco 7800 Series

Set Up UCR 2008 in Common Phone Profile
Use this procedure to set the following UCR 2008 parameters:
•
FIPS Mode
•
SSH Access
•
80-bit SRTCP
•
Web Access
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Phone Profile.
Step 2
Set the FIPS Mode parameter to Enabled.
Step 3
Set the SSH Access parameter to Disabled.
Step 4
Set the Web Access parameter to Disabled.
Step 5
Set the 80-bit SRTCP parameter to Enabled.
Step 6
Select Save.
Set Up UCR 2008 in Enterprise Phone Configuration
Use this procedure to set the following UCR 2008 parameters:
•
FIPS Mode
•
80-bit SRTCP
•
Web Access
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose System > Enterprise Phone
Configuration.
Step 2
Set the FIPS Mode parameter to Enabled.
Step 3
Set the 80-bit SRTCP parameter to Enabled.
Step 4
Set the Web Access parameter to Disabled.
Step 5
Select Save.
Set Up UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
154
Phone Feature Configuration