CHAPTER 7
Cisco IP Phone Accessories
•
Connect the Footstand, page 59
•
Headsets, page 59
Connect the Footstand
If your phone is placed on a table or desk, connect the footstand to the back of the phone.
Procedure
Step 1
Insert the curved connectors into the lower slots.
Step 2
Lift the footstand until the connectors snap into the upper slots.
You may need to exert more force than you expect to connect or disconnect the footstand.
Step 3
Adjust the angle of the phone.
You cannot adjust the Cisco IP Phone 7811 footstand.Note
Headsets
Although Cisco Systems performs internal testing of third-party headsets for use with Cisco IP Phones, Cisco
does not certify nor support products from headset or handset vendors.
The Cisco IP Phone 7811 does not support a headset.Note
The phone reduces some background noise that a headset microphone detects, but if you want to further reduce
the background noise and improve the overall audio quality, use a noise cancelling headset.
Cisco recommend the use of good quality external devices; for example, headsets that are screened against
unwanted radio frequency (RF) and audio frequency (AF) signals. Depending on the quality of headsets and
their proximity to other devices, such as mobile (cell) phones and two-way radios, some audio noise or echo
Cisco IP Phone 7800 Series Administration Guide for Cisco Unified Communications Manager
59
To Next Page
Loading...
Need help?
General
