Cisco 7962G Administration Guide

1-26
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 7.1
OL-18913-01
Chapter 1 An Overview of the Cisco Unified IP Phone
Overview of Configuring and Installing Cisco Unified IP Phones
5. If you are configuring the network settings on the
phone for an IPv4 network, you can set up an IP
address for the phone by either using DHCP or
manually entering an IP address.
Using DHCP—To enable DHCP and allow the DHCP
server to automatically assign an IP address to the
Cisco Unified IP Phone and direct the phone to a
TFTP server, choose Settings > Network
Configuration> IPv4 Configuration and configure
the following:
• To enable DHCP, set DHCP Enabled to Yes .
DHCP is enabled by default.
• To use an alternate TFTP server, set Alternate
TFTP Server to Yes, and enter the IP address for
the TFTP Server.
Note Consult with the network administrator to
determine whether you need to assign an
alternative TFTP server instead of using the
TFTP server assigned by DHCP.
Without DHCP—You must configure the IP address,
subnet mask, TFTP server, and default router locally
on the phone, choose Settings > Network
Configuration> IPv4 Configuration:
To disable DHCP and manually set an IP address:
a. To disable DHCP, set DHCP Enabled to No.
b. Enter the static IP address for phone.
c. Enter the subnet mask.
d. Enter the default router IP addresses.
e. Set Alternate TFTP Server to Ye s, and enter the IP
address for TFTP Server 1.
You must also enter the domain name where the phone
resides by Choosing Settings > Network
Configuration.
The Cisco Unified IP Phone supports having both IPv4
and an IPv6 address concurrently. You can configure
Cisco Unified Communications Manager to support
IPv4 addresses only, IPv6 addresses only, or support
both IPv4/IPv6 addresses.
See the “Configuring Startup Network Settings” section
on page 3-13.
See the “Network Configuration Menu” section on
page 4-5.
Table 1-8 Checklist for Installing the Cisco Unified IP Phones 7962G, 7942G, 7961G, 7961G-GE, 7941G, and 7941G-GE
(continued)
Task Purpose For More Information

Cisco 7962G Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Case material	ABS
Product color	Black, Grey
Wall mountable	Yes
Bluetooth	No
Security algorithms	128-bit AES, 802.1x RADIUS
Networking standards	IEEE 802.1Q, IEEE 802.1p, IEEE 802.1x, IEEE 802.3af
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Ethernet LAN (RJ-45) ports	2
Voice codecs	G.711, G.711a, G.722, G.729A, G.729ab, iLBC
Volume control	Digital
Display diagonal	5 \
Display resolution	320 x 222 pixels
Display number of colors	Monochrome
Caller ID	-
Lines quantity	- lines
Phonebook capacity	- entries
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Operating relative humidity (H-H)	10 - 95 %
Number of handles included	1 pc(s)

Weight and Dimensions

Depth	203.2 mm
Width	266.7 mm
Height	152.4 mm
Weight	1600 g