Cisco 8832 - Page 110

DescriptionDefaultField Type
Or Choices
Field Name
Enables LLDP-MED on the SW port.EnabledDisabled
Enabled
Link Layer Discovery
Protocol - Media
Endpoint Discover
(LLDP-MED): Switch
Port
Identifies the asset ID that is assigned to the phone for
inventory management.
String, up to 32 charactersLLDP Asset ID
Controls EEE on the switch port.DisabledDisabled
Enabled
Energy Efficient
Ethernet(EEE): Switch
Port
Assigns a phone power priority to the switch, thus
enabling the switch to appropriately provide power to
the phones.
UnknownUnknown
Low
High
Critical
LLDP Power Priority
Specifies the 802.1x authentication feature status.
• User Controlled—The user can configure the
802.1x on the phone.
• Disabled—802.1x authentication is not used.
• Enabled—802.1x authentication is used, and you
configure the authentication for the phones.
User ControlledUser Controlled
Disabled
Enabled
802.1x Authentication
Allows you to configure the speed and duplex function
of the phone SW port remotely. This enhances the
performance for large deployments with specific port
settings.
If the SW ports are configured for Remote Port
Configuration in Cisco Unified Communications
Manager, the data cannot be changed on the phone.
DisabledDisabled
Auto Negotiate
10 Half
10 Full
100 Half
100 Full
Switch Port Remote
Configuration
Controls the access to the SSH daemon through port
22. Leaving port 22 open leaves the phone vulnerable
to Denial of Service (DoS) attacks.
DisabledDisabled
Enabled
SSH Access
Controls the ringing pattern.DefaultDefault
Japan
Ring Locale
Controls the ability to resume a TLS session without
repeating the entire TLS authentication process. If the
field is set to 0, then the TLS session resumption is
disabled.
3600Integer 0–3600 secondsTLS Resumption Timer
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
100
Cisco IP Conference Phone Administration
Product Specific Configuration