Step 4 Select Save.
Set Up UCR 2008 in Common Phone Profile
Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• SSH Access
• Web Access
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose Device > Device Settings > Common
Phone Profile.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the SSH Access parameter to Disabled.
Step 4 Set the Web Access parameter to Disabled.
Step 5 Set the 80-bit SRTCP parameter to Enabled.
Step 6 Select Save.
Set Up UCR 2008 in Enterprise Phone Configuration
Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• Web Access
Procedure
Step 1 In Cisco Unified Communications Manager Administration, choose System > Enterprise Phone
Configuration.
Step 2 Set the FIPS Mode parameter to Enabled.
Step 3 Set the Web Access parameter to Disabled.
Step 4 Select Save.
Set Up UCR 2008 in Phone
Use this procedure to set the following UCR 2008 parameters:
• FIPS Mode
• SSH Access
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
112
Cisco IP Conference Phone Administration
Set Up UCR 2008 in Common Phone Profile