Cisco 8832 Administration Guide

Step 3 Press On.
Set Up the Wireless LAN from Cisco Unified Communications Manager
In Cisco Unified Communications Manager Administration, you must enable a parameter called “Wi-Fi” for
the conference phone.
In the Phone Configuration window in Cisco Unified Communications Manager Administration (Device >
Phone), use the wired-line MAC address when you configure the MAC address. Cisco Unified Communications
Manager registration does not use the wireless MAC address.
Note
Perform the following procedure in Cisco Unified Communications Manager Administration.
Procedure
Step 1 To enable the wireless LAN on a specific phone, perform the following steps:
a) Select Device > Phone.
b) Locate the required phone.
c) Select the Enabled setting for the Wi-Fi parameter in the Product Specific Configuration Layout section.
d) Check the Override Common Settings check box.
Step 2 To enable wireless LAN for a group of phones,
a) Select Device > Device Settings > Common Phone Profile.
b) Select the Enabled setting for the Wi-Fi parameter.
To ensure that the configuration in this step works, uncheck the Override Common Settings
check box mentioned in Step 1d.
Note
c) Check the Override Common Settings check box.
d) Associate the phones with that common phone profile using Device > Phone.
Step 3 To enable wireless LAN for all WLAN-capable phones in your network,
a) Select System > Enterprise Phone Configuration.
b) Select the Enabled setting for the Wi-Fi parameter.
To ensure that the configuration in this step works, uncheck the Override Common Settings
check box mentioned in Step 1d and Step 2c.
Note
c) Check the Override Common Settings check box.
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
43
Cisco IP Conference Phone Installation
Set Up the Wireless LAN from Cisco Unified Communications Manager

Cisco 8832 Specifications

General

Control type	Buttons
Display type	LCD
Product type	IP conference phone
Voice codecs	G.711a, G.711u, G.722, G.729A, G.729ab, OPUS, iLBC
Certification	CE Markings per directives 2014/30/EU and 2014/53/EU and 2014/35/EU \u2028 \u2028 UL 60950 Second Edition \u2028 CAN/CSA-C22.2 No. 60950 Second Edition \u2028 EN 60950 Second Edition (including A11 and A12) IEC 60950 Second Edition (including A11 and A12) EN 60950-1 IEC 60950-1 AS/NZS 60950.1 47CFR Part 15 (CFR 47) Class B AS/NZS CISPR32 Class B \u2028 CISPR32 \u2028Class B EN55032 \u2028 Class B EN 300 386 ICES003 Class B \u2028 VCCI Class B \u2028 EN61000-3-2 \u2028 EN61000-3-3 \u2028 EN61000-4-2 IEC61000-4-2 EN61000-4-3 IEC61000-4-3 EN61000-4-6 IEC61000-4-6 KN22 Class B \u2028 EN55024 \u2028 CISPR24 \u2028 KN24 Armadillo Light AS/ACIF S004 NZPTC220
Product color	Charcoal
Frequency range	100 - 20000 Hz
Built-in display	Yes
Display diagonal	3.9 \
Languages support	ARA, BUL, CAT, CHI (SIMPL), CHI (TR), CZE, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HEB, HUN, ITA, JPN, KOR, LAT, LIT, NOR, POL, POR, RUM, RUS, SER, SLK, SLV, SWE, TUR, UKR
Display resolution	480 x 128 pixels
Security algorithms	EAP-FAST, EAP-TLS, SHA-256, SSH
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet interface type	Fast Ethernet
Supported network protocols	IPv4, IPv6, SIP, SDP, UDP, DHCP, GARP, TFTP, HTTPS, RTP, RTCP, Cisco Discovery Protocol, LLDP
Cables included	USB
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 95 %
Operating relative humidity (H-H)	10 - 90 %
USB connector type	USB Type-C
RJ-45 ports quantity	1

Weight and Dimensions

Width	278 mm
Height	61 mm
Weight	1850 g