Cisco 8832 - Additional Troubleshooting Information

• 5 - Notification
• 6 - Information
• 7 - Debugging
Contact Cisco TAC for more information and assistance.
Procedure
Step 1 In the Cisco Unified Communications Manager Administration, select one of the following windows:
• Device > Device settings > Common Phone Profile
• System > Enterprise Phone Configuration
• Device > Phone
Step 2 Set the following parameters:
• Log Profile - values: Preset (default), Default, Telephony
• Log Profile - values: Preset (default), Default, Telephony, SIP, UI, Network, Media, Upgrade, Accessory,
Security, Energywise, MobileRemoteAccess
• Remote Log - values: Disable (default), Enable
• IPv6 Log Server or Log Server - IP address (IPv4 or IPv6 address)
When the Log Server cannot be reached, the phone stops sending debug messages.
Note
• The format for the IPv4 Log Server address is address:<port>@@base=<0-7>;pfs=<0-1>
• The format for the IPv6 Log Server address is [address]:<port>@@base=<0-7>;pfs=<0-1>
• Where:
• the IPv4 address is separated with dot (.)
• the IPv6 address is separated with colon (:)
Additional Troubleshooting Information
If you have additional questions about troubleshooting your phone, go to the following Cisco website and
navigate to the desired phone model:
https://www.cisco.com/cisco/web/psa/troubleshoot.html
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
173
Cisco IP Conference Phone Troubleshooting
Additional Troubleshooting Information