EasyManuals Logo

Cisco 8832 Administration Guide

Cisco 8832
190 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #162 background imageLoading...
Page #162 background image
DescriptionItem
Ratio of concealment frames to speech frames in the
preceding 3-second interval of active speech. If voice
activity detection (VAD) is in use, a longer interval
might be required to accumulate three seconds of
active speech.
Interval Conceal Ratio
Highest interval concealment ratio from the start of
the voice stream.
Max Conceal Ratio
Number of seconds that have concealment events (lost
frames) from the start of the voice stream (includes
severely concealed seconds).
Conceal Seconds
Number of seconds that have more than five percent
concealment events (lost frames) from the start of the
voice stream.
Severely Conceal Seconds
Estimate of the network latency, expressed in
milliseconds. Represents a running average of the
round-trip delay, measured when RTCP receiver
report blocks are received.
Latency
(see note)
Maximum value of instantaneous jitter, in
milliseconds.
Max Jitter
RTP packet size, in milliseconds, for the transmitted
stream.
Sender Size
Number of times RTCP Sender Reports have been
received.
Sender Reports Received
(see note)
Most recent time when an RTCP Sender Report was
received.
Sender Report Time Received
(see note)
RTP packet size, in milliseconds, for the received
stream.
Receiver Size
RTP packets that were received from the network but
were discarded from the jitter buffers.
Receiver Discarded
Number of times RTCP Receiver Reports have been
received.
Receiver Reports Received
(see note)
Most recent time when an RTCP Receiver Report was
received.
Receiver Report Time Received
(see note)
When the RTP Control Protocol is disabled, no data generates for this field and thus displays as 0.
Note
Cisco IP Conference Phone 8832 Administration Guide for Cisco Unified Communications Manager
152
Cisco IP Conference Phone Troubleshooting
Streaming Statistics Web Page

Table of Contents

Other manuals for Cisco 8832

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 8832 and is the answer not in the manual?

Cisco 8832 Specifications

General IconGeneral
Control typeButtons
Display typeLCD
Product typeIP conference phone
Voice codecsG.711a, G.711u, G.722, G.729A, G.729ab, OPUS, iLBC
CertificationCE Markings per directives 2014/30/EU and 2014/53/EU and 2014/35/EU \u2028 \u2028 UL 60950 Second Edition \u2028 CAN/CSA-C22.2 No. 60950 Second Edition \u2028 EN 60950 Second Edition (including A11 and A12) IEC 60950 Second Edition (including A11 and A12) EN 60950-1 IEC 60950-1 AS/NZS 60950.1 47CFR Part 15 (CFR 47) Class B AS/NZS CISPR32 Class B \u2028 CISPR32 \u2028Class B EN55032 \u2028 Class B EN 300 386 ICES003 Class B \u2028 VCCI Class B \u2028 EN61000-3-2 \u2028 EN61000-3-3 \u2028 EN61000-4-2 IEC61000-4-2 EN61000-4-3 IEC61000-4-3 EN61000-4-6 IEC61000-4-6 KN22 Class B \u2028 EN55024 \u2028 CISPR24 \u2028 KN24 Armadillo Light AS/ACIF S004 NZPTC220
Product colorCharcoal
Frequency range100 - 20000 Hz
Built-in displayYes
Display diagonal3.9 \
Languages supportARA, BUL, CAT, CHI (SIMPL), CHI (TR), CZE, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HEB, HUN, ITA, JPN, KOR, LAT, LIT, NOR, POL, POR, RUM, RUS, SER, SLK, SLV, SWE, TUR, UKR
Display resolution480 x 128 pixels
Security algorithmsEAP-FAST, EAP-TLS, SHA-256, SSH
Ethernet LAN data rates10, 100 Mbit/s
Ethernet interface typeFast Ethernet
Supported network protocolsIPv4, IPv6, SIP, SDP, UDP, DHCP, GARP, TFTP, HTTPS, RTP, RTCP, Cisco Discovery Protocol, LLDP
Cables includedUSB
Storage temperature (T-T)-10 - 60 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)10 - 95 %
Operating relative humidity (H-H)10 - 90 %
USB connector typeUSB Type-C
RJ-45 ports quantity1
Weight and Dimensions IconWeight and Dimensions
Width278 mm
Height61 mm
Weight1850 g

Related product manuals