EasyManuals Logo

Cisco Catalyst 3850 series User Manual

Cisco Catalyst 3850 series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #132 background imageLoading...
Page #132 background image
PurposeCommand or Action
Example:
Device(config-if)# ip igmp
proxy-service
•
When the mroute proxy service is enabled, the device periodically
checks the static mroute table for (*, G) forwarding entries that match
interfaces configured with the ip igmp mroute-proxy command (see
Step 7) based on the IGMP query interval. Where there is a match,
one IGMP report is created and received on this interface.
The ip igmp proxy-service command is intended to be used with
the ip igmp helper-address (UDL) command.
Note
•
In this example, the ip igmp proxy-service command is configured
on loopback interface 0 to enable the forwarding of IGMP reports out
the interface for all groups on interfaces registered through the ip
igmp mroute-proxy command (see Step 7).
Ends the current configuration session and returns to privileged EXEC
mode.
end
Example:
Device(config-if)# end
Step 12
(Optional) Displays multicast-related information about an interface.show ip igmp interface
Example:
Device# show ip igmp interface
Step 13
(Optional) Displays UDLR information for directly connected multicast
groups on interfaces that have a UDL helper address configured.
show ip igmp udlr
Example:
Device# show ip igmp udlr
Step 14
Related Topics
IGMP Proxy, on page 102
Example: IGMP Proxy Configuration, on page 108
Configuration Examples for IGMP Proxy
Example: IGMP Proxy Configuration
The following example shows how to configure the upstream UDL device for IGMP UDLR and the downstream
UDL device for IGMP UDLR with IGMP proxy support.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
108 OL-32598-01
Configuring IGMP Proxy
Configuration Examples for IGMP Proxy

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3850 series and is the answer not in the manual?

Cisco Catalyst 3850 series Specifications

General IconGeneral
ModelCisco Catalyst 3850 Series
RAM4 GB
Flash Memory4 GB
Stacking Bandwidth480 Gbps
Device TypeSwitch
Enclosure TypeRack-mountable
Routing ProtocolOSPF, EIGRP, BGP, RIP
Remote Management ProtocolSNMP, CLI, HTTP, HTTPS
FeaturesQuality of Service (QoS)
StackingYes
Memory4 GB RAM
Operating SystemCisco IOS
Relative Humidity10 - 95% (non-condensing)
Power Supply OptionsAC or DC
Ports24 or 48 10/100/1000 Ethernet ports

Related product manuals