CHAPTER 19
IP Multicast Optimization: IGMP State Limit
•
Finding Feature Information, page 387
•
Prerequisites for IGMP State Limit, page 387
•
Restrictions for IGMP State Limit, page 388
•
Information About IGMP State Limit, page 388
•
How to Configure IGMP State Limit, page 389
•
Configuration examples for IGMP State Limit, page 392
•
Additional References, page 394
•
Feature History and Information for IGMP State Limit, page 395
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for IGMP State Limit
•
IP multicast is enabled and the Protocol Independent Multicast (PIM) interfaces are configured using
the tasks described in the "Configuring Basic IP Multicast" module of the IP Multicast: PIM Configuration
Guide.
•
ALL ACLs must be configured. For information, see the see the " Creating an IP Access List and
Applying It to an Interface " module of the Security Configuration Guide: Access Control Lists guide.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 387
To Next Page
Loading...
Need help?
General
