Cisco Catalyst 3850 series

PurposeCommand or Action
Enables a filter for incoming MSDP SA messages.
ip msdp sa-filter in {peer-address | peer-name} [list
access-list] [route-map map-name] [rp-list access-list |
rp-route-map map-name]
Step 3
Example:
Device(config)# ip msdp sa-filter in 192.168.1.3
--Repeat Step 3 to configure incoming filter lists for additional
MSDP peers.
Step 4
Exits global configuration mode and returns to
privileged EXEC mode.
exit
Example:
Device(config)# exit
Step 5
Using TTL Thresholds to Limit the Multicast Data Sent in SA Messages
Perform this optional task to establish a time to live (TTL) threshold to limit the multicast data sent in SA
messages.
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
ip msdp ttl-threshold {peer-address | peer-name} ttl-value
4.
exit
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode.enable
Step 1
Example:
Device> enable
•
Enter your password if prompted.
Enters global configuration mode.configure terminal
Example:
Device# configure terminal
Step 2
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
224 OL-32598-01
Configuring MSDP
Using TTL Thresholds to Limit the Multicast Data Sent in SA Messages