CHAPTER 12
Configuring Basic IP Multicast Routing
•
Finding Feature Information, page 287
•
Prerequisites for Basic IP Multicast Routing, page 287
•
Restrictions for Basic IP Multicast Routing, page 288
•
Information About Basic IP Multicast Routing, page 288
•
How to Configure Basic IP Multicast Routing, page 290
•
Monitoring and Maintaining Basic IP Multicast Routing, page 301
•
Additional References, page 306
•
Feature History and Information for IP Multicast, page 307
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to www.cisco.com/go/cfn. An account on Cisco.com is not required.
Prerequisites for Basic IP Multicast Routing
The following are the prerequisites for configuring basic IP multicast routing:
•
To use this feature, the device or or active device must be running the IP services feature set. The IP
Services image contains complete multicast routing.
•
You must configure the PIM version and the PIM mode in order to perform IP multicast routing. The
switch populates its multicast routing table and forwards multicast packets it receives from its directly
connected LANs according to the mode setting. You can configure an interface to be in the PIM dense
mode, sparse mode, or sparse-dense mode.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
OL-32598-01 287
To Next Page
Loading...
Need help?
General
