PurposeCommand or Action
Configures SSM mapping to statically forward a (S, G) channel from the
interface.
ip igmp static-group group-address
source ssm-map
Step 4
Example:
Device(config-if)# ip igmp
Use this command if you want to statically forward SSM traffic for certain
groups. Use DNS-based SSM mapping to determine the source addresses of
the channels.
static-group 239.1.2.1 source
ssm-map
Returns to privileged EXEC mode.end
Example:
Device(config)# end
Step 5
Verifies your entries.show running-config
Example:
Device# show running-config
Step 6
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Device# copy running-config
Step 7
startup-config
Related Topics
Configuring DNS-Based SSM Mapping(CLI), on page 271
Verifying SSM Mapping Configuration and Operation, on page 276
DNS-Based SSM Mapping, on page 265
SSM Mapping Overview, on page 264
Verifying SSM Mapping Configuration and Operation
Perform this optional task to verify SSM mapping configuration and operation.
IP Multicast Routing Configuration Guide, Cisco IOS XE Release 3.6E (Catalyst 3850 Switches)
276 OL-32598-01
Configuring SSM
Configuring SSM Mapping
To Next Page
Loading...
